LK8GAPIIDT GAP IID Tool G3 and Replacement Key Kit
The GAP IID Tool and Replacement Key Kit, part number LK8GAPIIDT, pairs a GAP Diagnostic IIDTool G3 with a 315mhz flip style key blank so you can cut and program a replacement key for a Discovery 3 LR3 or a Range Rover Sport yourself.
Key programming is one of the most common reasons people buy an IID tool from us, so we put the two pieces together in one kit. The G3 handles the programming. The key arrives uncut, so a locksmith or a shop cuts it to match your Rover, and once it is cut you program it with the tool and you are done.
The G3 is the right generation for these platforms. It speaks CAN bus along with the LIN and DS2 buses that a 2005 to 2009 Rover uses, which is exactly what key programming on a Discovery 3 LR3 or a Range Rover Sport calls for.
Because the tool is yours afterward, it goes on doing everything else an IIDTool G3 does. Fault read and clear across every system on the vehicle, live data, service routines including the service reminder reset, manual component activation, air suspension height adjustment with guided calibration, and CCF editing. The advanced functions are enabled on the Rover you register the tool to, with one VIN license included.
FAQ
Is the key ready to use out of the box?
Not quite. The key is supplied as an uncut blank, so it needs cutting to match your Rover first. Any locksmith or shop can do that. After it is cut you program it yourself with the included G3.
Which Rovers does this kit cover?
The Discovery 3 LR3 from 2005 to 2009 and the Range Rover Sport from 2006 to 2009. Those are the platforms this key style and programming method apply to.
What can the G3 do once the key is programmed?
Everything an IIDTool G3 does. Read and clear faults across every system, watch live data, run service routines, adjust air suspension height, and edit the CCF on the vehicle you register it to.
Fits:
Discovery 3 LR3 L319 (2005 to 2009)
Range Rover Sport L320 (2006 to 2009)
Part Number: LK8GAPIIDT
Free shipping to the lower 48!
