D2BBK Front Bumper Hardware Kit - Discovery 1 & 2

The front bumper on the Land Rover Discovery 1 and Discovery 2 is held in place by four fasteners at the mounting points, and when those nuts and bolts corrode, strip, or go missing entirely, the bumper becomes a liability no matter how solid everything else looks. The D2BBK front bumper hardware kit is a complete replacement set of four nuts and four bolts designed specifically to restore proper bumper mounting on both the Discovery 1 (1989 to 1998) and the Discovery 2 (1998 to 2004).

These are the fasteners that do the actual work of keeping your front bumper seated correctly against the chassis. Whether you are reinstalling an original bumper after body repairs, fitting a heavy-duty replacement unit, or addressing hardware that has simply seen too many wet winters and muddy trails, the D2BBK gets the job done cleanly without a trip to the hardware store guessing at thread sizes.

The kit is a direct fit for the factory front bumper mounting points shared across both Discovery generations, making it equally useful for securing the original factory bumper or for mounting a heavy-duty steel winch bumper upgrade. Winch bumpers add considerable weight to the nose of the Rover, and having fresh, correctly rated hardware at the mounting points is especially important when the front end is working hard. Whether you are buttoning up a clean stock reinstall or finishing off a full front-end build with a new winch bumper, the D2BBK gives you the fastener foundation the job calls for.

Fits:

• Discovery 1 (1989 to 1998)
• Discovery 2 (1998 to 2004
  
  

Part Number: D2BBK

Free shipping to the lower 48!

No supersessions found.

FAQ

What does the D2BBK kit include?

The D2BBK kit contains four nut and bolt assemblies designed for the front bumper mounting points on the Discovery 1 and Discovery 2 L318. Every piece needed to remount the front bumper is included in a single kit, so there is no need to source individual fasteners separately.

Will this kit work with a heavy-duty replacement bumper as well as the original factory bumper?

Yes, provided the replacement bumper uses the standard factory mounting geometry shared by both the Discovery 1 and Discovery 2. The hardware in this kit is sized for the OEM chassis mounting points, which are retained by most compatible aftermarket and heavy-duty bumpers. If you are fitting a bumper with custom or non-standard mounting provisions, verify bolt sizing with the bumper manufacturer before ordering.

Does this kit fit all engine variants of the Discovery 1 and Discovery 2?

Yes. Front bumper mounting hardware is a body and chassis item, not an engine-specific component, so this kit is compatible with all engine and fuel type configurations available across both generations.