MRC5765 bulkhead sill bolt plate fits Land Rover Series II IIA III and Defender

MRC5765 Bulkhead Sill Bolt Plate – Series & Defender

$18.00

Secure your bulkhead and sill assembly properly with this Bulkhead Sill Bolt Plate (Part No. MRC5765). This plate provides the correct mounting interface between the sill and bulkhead, ensuring structural integrity and proper panel alignment on classic Series Land Rovers and Defenders.

Over time, original plates often rust, weaken, or distort, making replacement essential during restoration, sill replacement, or bulkhead repair. This component is manufactured to the correct dimensions for a clean, accurate fit.

Fits:

Series II, IIA, III
Defender 90 / 110 / 130

Install tip: Always pair new bolt plates with fresh hardware and inspect the sill ends for corrosion before refitting.*

Supersession Part Numbers

No supersessions found.

FAQ

Is this plate for one side or both sides?
This listing is for one (1) bolt plate. Order two if replacing both sides.

Does it fit both early Series and later Defender models?
Yes — MRC5765 is correct for all Series II/IIA/III and Defender variants.

Is welding required?
In most cases, no — it bolts in, but severe rust repair around the sill may require welding.

Part Number: MRC5765

Free Shipping Available to the Lower 48